EZIscreen Brush | Soft pure bristle for EZIscreen film | No damage from hard/abrasive nylon or synthetics

Soft bristle removes emulsion during washout

EZIscreenSKU: EZI-BRUSH


A pure bristle brush used during the washout process to remove the unexposed emulsion to reveal the design. Only required during washout process where initial water is unable to remove minor design areas.

$2.64

RRP $2.95
SAVE $0.31
In Stock

A pure bristle brush used during the washout process to remove the unexposed emulsion to reveal the design.

Our soft brush will not damage the film during washout, as some household paint brushes bristles are short and may damage the film when used too hard.

Only required during washout process where initial water is unable to remove minor design areas.

Remember, unline StencilPro, EZIscreen & Ikonart Films should not be soaked in water during the washout process.

SKU EZI-BRUSH
Barcode # 9334315037149
Brand EZIscreen
Shipping Weight 0.0200kg
Shipping Width 0.040m
Shipping Height 0.008m
Shipping Length 0.190m
Shipping Cubic 0.000061000m3
Unit Of Measure Pack

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law (ACL). You are entitled to a replacement or refund for a major failure. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Should you receive a product that does not meet your expectations, you may immediately return it for a refund or exchange - prior to opening or using the product.

Where products have been opened or used, suitability of usage has been determined and no refund is available for change of mind purchases on used products. This does not exclude warranty claims where product may be faulty or contain a manufacturing fault.

Calculate Shipping